CDL Air Brakes Practice Test

← All CDL practice tests

30 air brakes questions. Pick an answer to see whether it is right, with a short explanation and the handbook section. Your progress saves on this device.

1. At about what pressure does the air compressor governor stop the compressor (cut-out)?
2. At about what pressure does the governor let the compressor start pumping again (cut-in)?
3. The safety relief valve on the first air tank is usually set to open at:
4. Why must air tanks be drained?
5. When should manually operated air tank drains be used?
6. What is the most common type of foundation brake on heavy vehicles?
7. Air brakes are really three braking systems. Which list is correct?
8. What is a dual air brake system?
9. With a dual air system, how fast should pressure build from 85 to 100 psi at operating rpm?
10. In older single air systems (pre-1975), how fast should pressure build from 50 to 90 psi?
11. Brakes released, engine off: after the initial drop, what is the most air loss allowed in one minute for a single vehicle?
12. Brakes released: what is the most air loss allowed in one minute for a combination vehicle (two vehicles)?
13. Brakes released: what is the most air loss allowed in one minute for a combination of three or more vehicles?
14. Brakes fully applied (after the initial drop): what is the most air loss allowed in one minute for a single vehicle?
15. Brakes fully applied: what is the most air loss allowed in one minute for a combination vehicle (two vehicles)?
16. Brakes fully applied: what is the most air loss allowed in one minute for three or more vehicles?
17. When fanning off air in the low-air warning test, the warning must come on before pressure drops below:
18. On large buses, low-pressure warning devices commonly signal at about:
19. Tractor and straight-truck spring brakes come fully on when air pressure drops to:
20. The low air pressure warning light and buzzer come on while you are driving. What should you do?
21. How long does it take air brakes to start working after you push the pedal (brake lag)?
22. At 55 mph, brake lag adds about how much to your stopping distance?
23. With air brakes, total stopping distance at 55 mph is:
24. For a vehicle with air brakes, total stopping distance is:
25. Going down a grade you must push harder on the pedal to keep the same speed. What does that mean?
26. On newer vehicles, what does the parking brake control look like?
27. When should you avoid using the parking brakes?
28. A full service brake application must deliver to all brake chambers at least what share of air reservoir pressure?
29. What happens if you take the CDL skills test in a vehicle without air brakes?
30. Front-wheel limiting valves: what does the handbook say about front-wheel braking?

These are original practice questions written from the California Commercial Driver Handbook (DL 650), which follows the federal CDL knowledge test standards. Each answer names the handbook section it comes from. Tsai Electro is not affiliated with any DMV; your state handbook is the final word on its own test.

★ Resources
Scroll to Top
Not a licensed Professional Engineer in Texas or any U.S. state. Does not offer engineering services. Exam-prep education only.